Kentix KSS-BASIC-2-B Wartungshandbuch PDF herunterladen (Seite 20)



4.15.Connections - AlarmManager-BASIC/PRO

According to the two types of installation "Plug‘n Play" or "wired connection" you will find all connections of

the AlarmManager in the following overview. With the "Plug'n Play" installation you only need to open the

case to insert the SIM card. Pull the sides of the case a bit apart. The cover slips right out of the groove and

can easily be lifted off. You can insert the fixed connection cable from the rear of the chassis. Break out the

push-out marking from the inside with a screwdriver.

The terminal is designed for wire sizes up to 0.8 mm ².



Internal terminal 12 pole:

12 - GND

11 - Relay ALARM Armed-Active (NC)

10 - Relay ALARM Armed-Active (NO)

9 - Relay ALARM Armed-Active (COM)

8 - Relay ALARM Always-Active (NC)

7 - Relay ALARM Always-Active (NO)

6 - Relay ALARM Always-Active (COM)

5 - Power supply 10-32VDC (+/-)

4 - Power supply 10-32VDC (+/-)

3 - Ext. alarm input

2 - Ext. arm-disarm

1 - Internal system voltage (5V)

SIM mobile card.

Insert the card with the contacts to the

bottom (perforation down right) and close

the SIM holder.

IMPORTANT! Only insert the SIM card after

the initial configuration with a first PIN has

been uploaded.

ZigBee®

GSM

Power

10-32VDC

KENTIX

system jack

LAN

10/100Mbit

SMA

Push-Out

Cable-

insertion

POWER

GSM

ALARM

ARMED

KENTIX

system jack

Page  (04-2015, subject to change) kentix.com20

1 - GND

2 - DO1-LED

3 - DO2-LED

4 - Power supply 10-32VDC (+/-)

5 - Power supply 10-32VDC (+/-)

6 - Ext. alarm input (External dry contact, no/nc)

7 - Ext. arm-disarm (External dry contact, no/nc)

8 - 5V internal system voltage



Kentix system jack

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

Kentix KSS-BASIC-2-B Wartungshandbuch Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitsalarmsysteme Kentix KSS-BASIC-2-B